Q. > I try to install Access Point SNMP Config utility, but i can't find > menu.h file. > [root@server src]# make > gcc -O2 -Wall -c -o ap-cnf.o ap-cnf.c > ap-cnf.c:24:18: menu.h: No such file or directory > make: *** [ap-cnf.o] Error 1 A. You need to install ncurses and ncurses-devel packages from your distro. Or just build and install ncurses libs from sources. Q.[obsolete] > Something happened to my Linksys WAP11 AP today that I thought you > should know about. > > I tried your SNMP config utility this afternoon, and after displaying > some statistics screens (nice work, by the way!), I tried to go into the > config screen. The program hung, so I waited about a minute to see > whether it was going to do something, and then broke out of it. Trying > to run ap-cnf again, I found that I couldn't get it to work again. > > My access point is now dead, or as close to it as I've ever seen it. It > appears to have an IP address of 0.0.0.0 now, and it sends traps about > once a second. Running ethereal on the subnet where it's running shows > that the traps are malformed. It won't respond to the USB configuration > utility, either. A. For now I have 3 similar reports about such bugs using pre-0.8 program versions. Some solution may be. Did you try USB config for Win from Linksys what come with new version of firmware??? After upgrading firmware I'am reinstal usb driver and copy by hand file from driver DridDFU.sys to c:/windows/system and c:/windows/system32/drivers to replace old driver file. After this usb utility work fine with my AP. Q.[obsolete] > How do I enter a password when trying to log into the AP? A. You just need to enter ip of you AP and press enter, after this type password and press enter too. Password doesnt showed like unix login password, but it entered and stored in memory for futher access to you AP. Q. > I bought a access point. Unfortunately, the > documentation does not have the default community string used by the > product. Do you know what it is, or where I could find it out? A. I'm give you default communities from my equipment, may be you may use it with your AP: "public", "private", "linksys". Also consult documentation to your AP. Q. > The wireless & ethernet stats are reset to zero each time I grab > the KnownAP signal and quality stats. The same issue happens when > performing KnownAP's running your AP-CNF program without modification. A. Because only way to see KnownAPs info its to put AP to client mode with master AP mac set to 0000000000. When setting this AP resets. Only one way to get signal and quality stats not resetting AP - its to get this stat from AP setted in client mode all time.